Hayward 3429LEDBL Manual Del Usuario página 7

EN
INSTALLATION
Technical Specifications
• The light should shine in the opposite direction to
the house or terrace so as not to dazzle.
• The light should be placed at a maximum depth of
30 cm below the swimming pool stone crown the
axis of the bulb.
• The hermetic tightness of the outlet and the
sheath will be carried out according to good
practice.
• This is a class III light, with a protection index of
IP68, 1m. The bulb has a very low power voltage
of 12 VAC for safety.
• During installation, provide sufficient cable length
to be able to change the bulb out of the water.
Structure Built in the Liner
• Seal the light cable gland (ref. 3353) in the
construction, in such a way that the front part is at
the same level as the tiles or the lining.
• Screw the sheath into the light niche, making a
hermetic seal.
• Screw the set into the cable gland, making
another hermetic seal.
• Put the gasket on the front part of the light niche.
• Put the gasket on the flange of the light niche.
• Affix the hermetic sealing flange after putting
the liner.
• Cut out the liner inside the niche.
• Thread the light optic cable through the sheath
up to the junction box (ref. 3495EURO). Place the
optic in front of the niche following back along the
cable in the junction box, and fix the optic onto the
plastic support.
• Pull and wind up the cable in the junction box and
hermetically seal the junction box.
Liner panel structure:
• Make a 110 mm hole in the panel.
• Place the light niche inside the swimming pool.
Tighten the nut behind (ref. 3492) to fasten it.
• The process of hermetically sealing the liner,
the sheath cable and the placement of the light
optic is the same as for the liner light.
Structure under construction without liner
• Seal the cable gland (ref. 3352) to the
construction, in such a way that the front part is at
the same level as the tiles or lining.
• Screw the light niche into the cable gland.
• The process of hermetically sealing the liner,
the sheath cable and the placement of the light
optic is the same as for the liner light.
30 cm
1B
1 V
Only use Hayward ® replacement parts
7
PRHX7010 2 RGB
2 White
PRHX7009
2
PRHX20LDRVB
PRHX20LDW
1 V
1B
Rev. C