Publicidad
Idiomas disponibles
Idiomas disponibles
Seadoo Rotax 300 2010-2023 Adapter Harness
6. Confi guration steps
For correct harness installation follow the steps below.
Start by going to your "Sample Start Maps" folder after installing the 5.0 or
newer version of FTManager.
This tune contains all the inputs, outputs, engine settings and a base tune for
a stock unmodifi ed engine. Proper tuning will be required and use of this fi le
is at your own risk as it is only meant to help you with the initial setup of your
new FuelTech system.
IMPORTANT
EN
The Maps in this section should be used only as a BASE/EXAMPLE
to start tuning your engine for the fi rst time!
It is still mandatory to have an experienced tuner check all of
the input and output confi gurations to ensure they are all prop-
erly setup with your specifi c installation before any of your new
electronic equipment is powered up and your engine is started
for the fi rst time.
The downloading and use of these maps from this section is your
sole responsibility. FuelTech is not responsible for any damages
caused to your vehicle/installation by using the maps available
in this folder.
a.
b.
c.
d.
8
First step is downloading FTManager software, Then ensure your ECU
is updated to 5.0 version or newer, Next open the FTManager software
and plug your ECU into your laptop using the supplied USB cable.
Go to the "Tools" tab (1) click on the "ECU Updater" button (2) now click
on the update button (3).
1
2
After fi nished the update, write the map in the ECU
Check the confi gured inputs and outputs on the map. To do so, access
the menu "Sensors and Calibration/Inputs" (4) and "Sensors and
Calibration/Outputs" (5).
3
Publicidad
