Publicidad
Preparation
Assembly and disassembly of the tip.
• Insert the tip into the tip holder until it stops. The
magnetic tip holder allows the tip to be secured.
• To change the screwdriver tip, turn the depth
adjustment knob to the maximum and remove the tip.
Pliers are sometimes required to remove the accessory.
Start up
Start Up and Operation Control
• Intermittent operation:
Connect the plug into the power outlet.
Press the switch (A) to start the screwdriver.
Speed increases when applying more pressure on the switch.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power outlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
CAUTION
During the operation the motor will be running but the tip
will not turn until the screw applies pressure in the material. This feature is
useful to insert the screw in the tip before screwing it into the material.
Rotation Direction
• The screwdriver rotation direction is controlled by the rotation
direction selector button (C). This function enables the screwing and
unscrewing function.
• To screw press the button with the arrow pointing towards the tip
holder.
• To unscrew press the button with arrow pointing towards the
handle .
Screwing depth adjustment
• The depth stop can be adjusted so that screws can be attached to a
specific depth, determined by the needs of the job.
• Follow the chart on the collar to increase or decrease the depth of
the screwing.
• To set the screw deeper into the workpiece, turn the adjust knob to
the right.
• To set the screw higher into the workpiece, turn the adjust knob to
the letf.
C
A
Deeper
1
ENGLISH
B
7
Publicidad
