TAD D700 Manual De Instrucciones página 12

Power unit rear panel / Main unit rear panel
Power unit
DC2 DC OUTPUT
ON
POWER
OFF
1
1 Main power switch (POWER ON/OFF)
Use to switch main power ON/OFF. Press upper side to turn power ON, then press the  button on the remote control or
main unit to set the unit to standby/ON mode. Press the lower side of this switch to turn the main power OFF.
2 AC IN connector
Connect the supplied power cord here.
3 DC OutPut connectors (DC1/DC2)
Connect the supplied DC cord to the main unit.
4 DIgItAL INPut connectors
Connect to a component equipped with a digital output connector.
• XLR (balanced) type (D1)
• COAXIAL type (D2)
5 DIgItAL OutPut connector
Connect to a component equipped with a digital input connector.
• XLR (balanced) type
• COAXIAL type
6 DC INPut connectors (DC1/DC2)
Connect the supplied DC cord to the power unit.
7 ANALOg OutPut connectors
Connect to Pre-Amplifier.
• UNBALANCED RCA type
• BALANCED XLR type
12
Main unit
DC1
AC IN
2 3 4
DIGITAL INPUT
COAXIAL XLR
D2 D1
2 1
3
DC2
COAXIAL XLR
DIGITAL OUTPUT
5
ANALOG OUTPUT
R
UNBALANCED
DC1
DC INPUT
R
BALANCED
6
L
L
7