TAD D700 Manual De Instrucciones página 19

Symptom
Volume level is A difference may occur due to different
different when playing recording formats for the two kinds of discs.
SACD compared to
CDs.
No sound is produced Digital connection is not correct.
for digital input.
On a CD player equipped with digital output
level adjustment, the output level is set too low.
The file format is not supported by the
computer's digital playback software.
Digital recording can't ' Some recorders may be unable to record
be performed from
digital outputs. ' Recording may not be possible when playing
The power turns off by If the ECO (power-saving) mode is turned ON,
itself. the unit will automatically enter standby mode
if no operation is performed on the unit for 20
minutes.
Display is not visible. The display viewing angle is within 45° to right/
left from the front of the unit.
The unit is set to display off.
The remote control ' The remote control's batteries are expended.
doesn't work. ' The remote control is being used too far
' Angle is bad.
' Line of sight to the main unit is blocked.
' Strong light from a fluorescent lamp or other
Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power cord and
then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem, please consult your
dealer.
This unit is designed as a consumer audio product (audio/video component). It is not designed for long continuous
use as a commercial BGM source, nor for use in automobiles, ships, or outdoors.
Possible cause
output when connected to 88.2 kHz output.
CD-R or other discs with copy protection.
away from the main unit.
light source is directly striking the signal
receiver.
Remedy
This is not a malfunction of this unit.
Check the digital connection.
Adjust the player's digital output level to an
appropriate level.
If the output device is set to a non-PCM audio
signal format (Dolby Digital, DTS, etc.), set it to
PCM.
' Try switching to 44.1 kHz output.
' Can't record.
Set the ECO (power-saving) mode to OFF
(page 17).
View the display from immediately in front of the
unit.
Press the DISP OFF button of the remote control
unit to reset the lighting-off function.
' Replace the batteries with new ones.
' Use the remote control from within a distance
of 7 meters (23 ft.), and within an 30° arc to
right/left of the unit's front panel.
' Remove obstacles between the main unit
and remote control, or change to a different
location when operating the remote control.
' Readjust the position of lamps or other light
sources so that strong light does not strike
the signal receiver.
TAD-D700 19