IKEA LAGAN Manual Del Usuario página 20

ENGLISH
release handle, then remove the filter
downwards.
3. After cleaning the grease filter, remount in
reverse order ensuring the entire extraction
surface is covered.
Charcoal filter maintenance (if the hood is
installed in recirculation installation)
1. Pull out the plug or disconnect the power
supply.
2. Remove the grease filter
3. If the carbon filters are already fitted (two
filters that cover the protective grilles for the
motor impeller) and have to be replaced,
turn the central handle anti-clockwise to
unlock them.
4. Open the two filter shells
5. Pull out the two circular mats
6. Proceed in reverse order to fit the new
filters.
7. Refit the grease filters.
Unlike traditional charcoal filters, this
charcoal filter can be washed and
reactivated.
Care and cleaning long life Charcoal filter
• The anti-odour filter shall be washed and
regenerated every 3-4 months (or more
frequently if the hood is subject to intensive
use), up to a Max. of 8 regeneration cycles
Lamp Power Socket Voltage
(W)
3 E14
(in case of particularly intensive use it is
recommended that you do not exceed 5
cycles).
Regeneration procedure:
• Wash in the dishwasher at a MAX
temperature of 70° or hand wash in hot
water without using abrasive sponges (do
not use detergents!)
• Dry in the oven at a MAX temperature of
70° for 2 hours or dry at room temperature,
standing the filter in a vertical position to
facilitate drainage.
Lamp maintenance
Disconnect the hood from the power supply.
Open the extractor grille or remove the self-
supporting grease filter.
Replace the damaged lamp. Use E14 3W max
LED lamps only.
Refit the extractor grille or grease filter.
IMPORTANT: make sure you don't touch the
lamp with your bare hands.
LCL
(V)
230 55
ILCOS D Code
DRGSB/C/UB-3/27/
1B-230-E14-55
20