fatboy FLAMTASTIQUE XS Manual página 7

35mm wide x 1mm thick cotton wick
(approx. 20cm long) to ensure the best
user experience.
Refilling:
- Before refilling the fuel container
please make sure the Flamtastique XS
is turned off and that all the parts have
cooled down.
- Remove the burner (with the round
handle) by turning it counterclockwise
from the fuel container.
- The wick might leak some oil so make
sure not to spill any on vulnerable
surfaces!
- Refill the fuel container to the maxi-
mum level shown on the fuel container.
- Re-assemble the burner by turning
it clockwise on to the fuel container.
Hand-tight is just fine.
Cleaning:
- Flamtastique XS can easily be cleaned
using a moist cloth with lukewarm
water. Take off the chimney before
cleaning. Please ensure the fuel
chamber is empty (or nearly empty)
to avoid spilling!
- Before cleaning the chimney make
sure it has cooled down and carefully
remove it from the center part. The
chimney can be cleaned using water
and soap. NOTE: MAKE SURE THE PART
HAS COOLED DOWN.
Trouble shooting:
My Flamtastique XS is not working:
- Make sure the fuel container is properly
filled (there is an indicator on the con-
tainer showing the maximum
filling level).
- Make sure there is enough remaining
wick (inside the glass chamber) to be
submerged into the fuel.
- Make sure the wick is set to length
before use, The round handle can be
rotated to adjust the wick length. In or-
der to do so please make sure the screw
in the center of the wick is released for
the wick to move freely.
- If the wick burned to a minimum
please install a new one. (35mm x1mm).
- After not having being used for a while
the wick might dry out. It might help to
turn the round handle and extend the
visible length of the wick. Or you can
dip the visible part of the wick in the
fuel chamber (upside down) to make
sure it's moist and able to ignite.
- If the mechanism is stuck, the wick
might be hardened after being unused
for a longer period of time.
It might help to take the chimney and
the fuel chamber off, and leave the
center part in a bowl filled with hot
water for a while. This will make the
wick flexible again. If the Mechanism is
working again please leave the part, in-
cluding the wick, to dry before reassem-
bling the fuel container and chimney.
This problem might appear when using
paraffin oil. Please make sure the center
screw is released in order for the wick
to move freely.
- The chimney is broken. A broken chim-
ney might be caused by water drips
hitting the hot glass surface. Try to
avoid fluids splashing on the chimney
while burning.
- The lamp is flickering. Make sure the
wick length is set to an ideal length by
7 - EN