Parkside PAFS 550 A1 Traducción Del Manual De Instrucciones Original página 15

Before use
Assembly
NOTE
► You can assemble the appliance using two
adjustable spanners (not supplied).
► Alternatively, you can also use a 16 mm and
19 mm wrench (not supplied).
♦ Fit the high-pressure hose w onto the connecting
thread r on the appliance. Tighten the nut
using an adjustable spanner. Counter the nut
of the connection thread r with a second
adjustable spanner (see fig. A).
♦ Fit the other end of the high-pressure hose w to
the connecting thread of the paint spray gun 0.
Tighten the nut using an adjustable spanner.
Counter the nut of the connection thread of
the paint spray gun with a second adjustable
spanner.
Selecting/changing the nozzle
Nozzle
Nozzle 311
Nozzle 517
♦ Insert the appropriate nozzle 5 into the nozzle
chamber p with the tip pointing in the spray
direction (see fig. F).
Replacing the HEA filter
WARNING!
► The system must be depressurised in order
to carry out the following work. To do this,
follow the instructions in the section "Depres-
surising the appliance".
♦ Remove the high-pressure hose w from the
paint spray gun 7.
♦ Turn the handle 8 anticlockwise until the upper
end can be detached from the paint spray
gun 7 (see fig. B). You can attach an adjust-
able spanner to the lower end of the handle to
help.
■ 10 │ GB │ IE
Use
low viscosity spray material
viscous spray material
♦ Insert the appropriate HEA filter q for the
installed nozzle 5:
– white HEA filter (pre-fitted): nozzle 517
– yellow HEA filter: nozzle 311
♦ Screw the handle 8 clockwise back into the
thread of the paint spray gun 7.
NOTE
► Clean the HEA filters q regularly and
replace them, if necessary. You can obtain
replacement filters from the service hotline
given in the section "Service".
Using the appliance
♦ Place the suction hose 2 and return hose 1
into the paint bucket (see fig. L).
♦ Press the valve trigger z to ensure that the
valve is free of any blockages.
♦ Insert the plug into a mains power socket.
♦ Turn the function switch e to the vertical
position (PRIME).
♦ Turn the pressure regulator dial 3 to position
2 to ensure that the paint is pumped through
the system.
♦ Wait until the paint runs through the return
hose 1 back into the paint bucket. Turn the
pressure regulator dial 3 to position 0 (off).
NOTE
► If no paint comes out, carry out the steps
described in the section "Eliminating suction
problems".
♦ Turn the function switch e to the horizontal
position (SPRAY).
♦ Turn the pressure regulator dial 3 to a level
corresponding to the viscosity of the sprayed
material.
♦ Hold the paint spray gun 7 over an empty
container.
♦ Unlock the paint spray gun 7 by turning the
safety catch 6 so that its tip is facing down.
PAFS 550 A1