Parkside PAFS 550 A1 Traducción Del Manual De Instrucciones Original página 18

♦ Release the trigger 9 as soon as the cleaning
fluid starts flowing out.
♦ Lock the paint spray gun 7 by turning the safety
catch 6 with the tip as far back and up as
possible.
♦ Turn the function switch e to the vertical posi-
tion (PRIME).
♦ Unlock the paint spray gun 7 by turning the
safety catch 6 so that its tip is facing down.
♦ Drain off the remaining paint by pulling the
trigger 9. Hold the paint spray gun 7 over the
detergent container while doing so.
♦ Release the trigger 9 as soon as clear cleaning
fluid starts flowing out.
♦ Make sure that no detergent residue remains in
the appliance. If necessary, rinse it again with
water.
♦ Lock the paint spray gun 7 by turning the safety
catch 6 with the tip as far back and up as
possible.
♦ Turn the pressure regulator dial 3 to position
0 (off). Remove the plug from the mains socket.
♦ Depressurise the appliance.
♦ Remove the high-pressure hose w from the
paint spray gun 7 with the aid of an adjustable
spanner.
♦ Disassemble the nozzle holder a along with
the nozzle 5, saddle washer o and plastic
ring i (see fig. F). Clean all parts thoroughly
using suitable cleaning agents.
♦ Lock the paint spray gun 7 by turning the safety
catch 6 with the tip as far back and up as
possible.
NOTE
► Clean the HEA filters q regularly. Replace
them if cleaning is no longer sufficient.
♦ Disconnect the suction hose 2 and the return
hose 1 from the appliance using the hose
clips l. Clean the outsides of the hoses.
♦ Remove the filter plate u of the intake filter t
(see fig. E).
PAFS 550 A1
♦ Clean the filter plate u thoroughly under
running water.
♦ Remove the high-pressure hose w from the
connecting thread r using an adjustable
spanner. Counter the connection thread r
using a second adjustable spanner.
♦ Dip the inlet valve h into a container filled with
approx. 250 ml of conservation agent (a fine,
acid- and resin-free oil, e.g. Shell Corena
S2 P 68/P 100/P 150) so that it can be sucked
in (see fig. M).
♦ Insert the plug into a mains power socket.
♦ Turn the function switch e to the vertical posi-
tion (PRIME).
♦ Hold a cloth in front of the connecting thread r
(see fig. N). Turn the pressure regulator dial 3
to position 1 for about 30–60 seconds. This
helps to preserve the appliance. The oil is
discharged again through the outlet of the
return hose 1. Turn the pressure regulator
dial 3 to position 0 (off).
♦ Remove the plug from the mains socket.
♦ Then dismantle the paint spray gun 7 and
remove the HEA filter q in the handle 8. If
necessary, clean all of the components of the
spray gun again using a brush. Oil all of the
parts with a fine, acid- and resin-free oil, and
store the oiled parts in a dust-proof location.
♦ Before using the appliance again, rinse it
thoroughly with warm water to remove any
oil residues.
GB │ IE │ 13 ■