www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
-
Unscrew the screws and remove the cov-
er (5 Fig. B).
-
Inside the compartment, locate and con-
nect the connector (6 Fig. C) to the re-
ceiver unit (1 Fig. C).
STORAGE AND USE
-
Insert the main plug (7 Fig. D) of the vac-
uum unit into the socket.
-
Turn the main switch (8 Fig. E) of the suc-
tion unit to "
Storage of the suction start button
-
Move the remote control (2 Fig. F) near
the receiver (1 Fig. G).
-
On the receiver, press and hold the but-
ton (11 Fig. G): the LED (12 Fig. G) flash-
es slowly.
-
Press the left button on the remote con-
trol (9 Fig. F).
-
The LED (12 Fig. G) flashes quickly on
the receiver.
-
On the remote control, press the left but-
ton a second time (9 Fig. F): the led (12
Fig. G) on the receiver turns to steady
light. After a few moments the LED (12
Fig. G) turns off.
-
Release the button (11 Fig. G). Operation
complete.
Storage of the suction stop button
-
Using the remote control (2 Fig. F), move
close to the receiver (1 Fig. G).
-
On the receiver, press and hold the but-
ton (11 Fig. G): the LED (12 Fig. G) flash-
es slowly.
-
Press the right button on the remote con-
trol (10 Fig. F).
".
-
The LED (12 Fig. G) flashes quickly on
the receiver.
-
Press the right button on the remote con-
trol a second time (10 Fig. F): the led (12
Fig. G) on the receiver turns to steady
light. After a few moments the LED (12
Fig. G) turns off.
-
Release the button (11 Fig. G). Operation
complete.
Once memorized, press the left button (9
Fig. F) on the remote control to start suction.
Press the right button (10 Fig. F) on the re-
mote control to stop suction (the suction unit
stops after 10 sec.).
-
Mount the receiver unit (1 Fig. H) on
the suction unit and fix it with the screws.
-
Insert the remote control (2 Fig. I) in the
protective shell (3 Fig. I).
-
If necessary, fix the shell with the remote
control to the suction pipe by using the
strap (4 Fig. I), as shown in Figure I.
NOTE:
Since at each command the transmitted code
changes, if the transmission is interrupted by
a disturbance, the receiver expects a differ-
ent code, therefore to re-establish the com-
mand it is necessary to release and press
the remote control button again.
ENGLISH - 3