Cleaning And Maintenance - Bestron AAC7000 Manual Del Usuario

USAGE - Remote control
The device can also be controlled with the included remote control. The remote control requires two AAA-
batteries (not included). Open the battery compartment on the underside, place the batteries, and close the
lid. The buttons on the remote control function the same as the buttons on the control panel.
For an optimal functioning:
• Make sure the distance between the ventilator and the remote control is not more than 6 metres.
• Aim the remote control at the device and make sure the direction angle is smaller than 30 degrees.
CLEANING AND MAINTENANCE - General
After a period of time, dust can get into the rosters and the slats of the device.
1. Turn off the device and pull the plug from the socket.
2. Remove the dust of the rosters and slats with a hand brush and/or vacuum cleaner.
3. Clean the casing with a soft, moist cloth. Never immerse the device in water. Make sure no moist can
get into the electrical connections.
CLEANING AND MAINTENANCE - Water drainage
The device has an internal water collection tray. When it is full, the device stops functioning and the indication
light lights up on the control panel at "
1. Turn off the device and pull the plug from the
socket.
2. Place the device on an elevation, and place a
bucket or other kind of collection tray underneath
the drain hole of the water collection tray.
3. Unscrew the lid and plug of the drain hole (figure
1, No. 12), see figure 6. The water streams from
the water collection tray in the bucket.
ATTENTION:
• Carefully move the device and keep it upright at all times, to prevent spillage of the water over the brim
of the internal water collection tray. During emptying, you can slant the device slightly to remove the last
water from the water collection tray.
• If the bucket, or other kind of collection tray, cannot collect all the water at the same time, put the lid and
plug of drain hole back. Empty the bucket and repeat the steps.
4. If the water collection tray is empty, put the lid and plug back in the drain hole, and make sure it is
properly closed.
Continuous drainage
If you often use the device to dehumidify the air, you
can also use the continuous drainage. Attention:
continuous drainage only works in the "
mode.
1. Turn off the device and pull the plug from the
socket.
2. Unscrew the lid and plug from the continuous
drain hole (figure 1 No. 9), see figure 7)
3. Connect a drainage hose (not included) to the
continuous drain hole, and make sure the end of
the hose is placed in a bucket, or other kind of
collection tray.
4. Use the device as prescribed in this manual.
".
water full
"-
dehum
36
EN
6
7