Problem Solving - Bestron AAC7000 Manual Del Usuario

CLEANING AND MAINTENANCE - Cleaning the filter
For an optimal result, you have to clean the EVA-filter every two weeks, and replace at least 1x per year, or
more often if the filter is visibly full. Also clean the filter before you store it for longer periods of time, or when
you use it again after a long time.
1. Turn off the device and pull the plug from the
socket.
2. Use a cross-head screwdriver to remove the
filter from the back of the device (the middle
screw, see figure 8).
3. Rinse the filter with lukewarm water, or have it
soak in soapy water.
4. Let the filter dry properly.
5. Put the cleaned (or new) filter back in the device
and fixate it.
ATTENTION:
• If the filter has not dried properly, water can
enter the device. This could cause (electrical)
damage.

PROBLEM SOLVING

Problem Possible cause
The air- There is no electricity
conditioning is not
functioning The room temperature is
lower than the set cooling
temperature
In the cooling mode: the
room temperature is too low
or too high
In the dehumidifying mode:
the room temperature is too
low
The device is standing in
sunlight
Cooling is not Doors or windows are open
functioning
properly Central heating or other
sources of heat
The filter is dirty or clogged
The inlets or outlets are
blocked
The device makes The device is not placed on a
a lot of noise stable and flat surface
Compressor does The device is overheated
not function
Advised solution
Check whether the socket the device is connected
to, has electricity
Change the set cooling temperature
The device optimally functions at a room
temperature between 7°C and 35°C
The device optimally functions at a room
temperature of 17°C and higher
Move the device into the shade
Close open doors and windows
Turn off the heating
Clean the filter
Remove obstructions
Place the device on a stable and flat surface
Wait a couple of minutes until the temperature has
lowered and restart the device
37
EN
8