Publicidad
SWAP OUTLET SIDE (OPTIONAL)
NOTE: Electrical box assembly is shipped with the outlet mounted on the right-hand side.
If desired, follow steps 2 through 3 to mount the outlet on the left-hand side. Otherwise,
proceed to INSTALLATION on page 8.
2. Disconnect the Black and White Power Wires for the outlet and Black (L) and White (N)
Power Wires for the 12v driver from the WAGO terminals inside the assembly by lifting up
on the orange tab for each terminal. Set the loose 3 tab WAGO terminal blocks aside for
reassembly later.
Remove the two #6-32 x 1/4" screws [203-1115] securing the outlet and the two
#6-32 x 1/4" screws [203-1115] securing the driver.
Disconnect the JST connectors (white) between the power supply and the circuit board
(located at the top of the electrical box assembly).
©2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
Part no. CB-209-1346 09/23/20
800.877.2376
www.robern.com
Portray Electric Upgrade
4
Publicidad
