Layout And Items Supplied; Proper Use; Technical Data - EINHELL TC-AC 420/50/10 V Manual De Instrucciones Original

2. Layout and items supplied

2.1 Layout (Fig. 1-4)
1. Intake air fi lter
2. Pressure tank
3. Wheel
4. Foot
5. Quick-lock coupling (regulated compressed
air)
6. Pressure gauge (for reading the set pressure)
7. Pressure regulator
8. On/Off switch
9. Transport handle
10. Safety valve
11. Drainage screw for condensation water
12. Pressure gauge (for reading the vessel pres-
sure)
13. Quick-lock coupling (unregulated com-
pressed air)
14. Oil sealing plug
15. Oil level window
16. Overload switch
17. Oil fi ller opening
18. Handle
19. Oil drainage screw
20. Wing nut
21. Screw
22. Washer
23. Nut for fi tting the foot
24. Axle screw
25. Nut
26. Nut for fi tting the axle
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
nearest branch of the DIY store where you made
your purchase at the latest within 5 days after
purchasing the article and upon presentation of
a valid bill of purchase. Also, refer to the warranty
table in the warranty provisions at the end of the
operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Anl_SA_TC_AC_420_50_10_V_SPK8.indb 29 Anl_SA_TC_AC_420_50_10_V_SPK8.indb 29
GB
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Compressor
•
Intake air filter (2x)
•
Wheel (2x)
•
Foot (2x)
•
Oil sealing plug
•
Screw (2x)
•
Washer (2x)
•
Nut for fitting the foot (2x)
•
Nut (2x)
•
Nut for fitting the axle (2x)
•
Axle screw (2x)
•
Original operating instructions

3. Proper use

The compressor is designed for generating
compressed air for tools operated by compressed
air.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

See warranty card of your country.
Noise
The noise emission values were measured in ac-
cordance with EN ISO 3744.
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
- 29 -
03.06.2019 15:24:14 03.06.2019 15:24:14