Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions
*Place a counterweight such as an offset umbrella base (not
included) that can be filled with water or sand, or triangular
weight bases (not included) before proceeding further. An offset
umbrella base should be able to hold 150 lbs. of sand or water,
or 4 triangular weight bases, minimum 38 lbs. each. This is the
recommended amount of weight to maintain product stability,
especially while umbrella canopy is open.
Fig. 6
Prong
F
Band
STEP 4:
Place the pole of the Umbrella Frame (A) inside of the Bottom Pole (G)
so that the prongs fit within groves at the top of this part, see Fig. 6.
Insert Locking Knob (F) through band found at the top of part G, and
into the bolt-threading of this part, see Fig. 6. Insert second Locking
Knob (F) into bolt-threading underneath band. Tighten the Locking
Knobs (F) until pressed against the pole of the Umbrella Frame (A)
enough to hold it in place, see Fig. 6. Over tightening may dent or chip
away at the protective coating of the Umbrella Frame (A).
12
Publicidad
