Publicidad
Idiomas disponibles
Idiomas disponibles
7. Connecting the wires
CAUTION! The electrical installation to which the machine would be connected should be equipped
with an overcurrent fuse.
If an extension cord is used, its cross-section should be at least the same as that of the power cord.
CAUTION! Connecting the cables to the device must be done with the power supply disconnected
and the device turned off.
Welding using the MIG/MAG method
1) Insert the welding gun cable plug into the Euro MIG/MAG output socket on the front panel of
the machine and tighten it.
2) Insert the ground wire plug into the terminal marked "-" on the front panel of the welding
machine and tighten it clockwise.
3) Insert the polarity reversal plug into the terminal marked with the "+" symbol on the panel
inside the welding machine (where the welding wire is to be installed) and tighten it
clockwise:
ON/OFF: Main switch ON/OFF (on/off)
AC 36V: Gas heater socket
TIG/CUT GAS: TIG welding gas/air connection
for CUT plasma cutting
MIG GAS: gas connection for MIG welding
Publicidad
