Publicidad
Idiomas disponibles
Idiomas disponibles
|
Electronic Module Orientation
The display can be rotated 180° for user preference.
1.
Remove protective rubber boot and set aside.
2.
Remove the 4 screws retaining electronic module using a
T-20 Torx driver.
3.
Remove module and rotate 180°. Ensure that foam pad under
batteries is reinstalled correctly if it falls out. This is critical
to ensure batteries are not dislodged if meter is exposed to
rough handling.
4.
Reintall the 4 screws. Torque screws until module is fully seated.
Recommended installation torque is 5-10 in-lb (0.6-1.1 Nm).
Over torquing will crack module.
5.
Reinstall the protective rubber boot.
CAUTION
When reinstalling screws for electronic module, ensure grounding tabs are captured under heads of screws to ensure proper ground and
protection against static discharge when handling meter.
Operational Functions
Turns meter on and displays accumulated total while pressed. If accumulated total is larger than 9999, numbers will scroll across screen
in 4 digit groups.
Hold for 3 seconds to reset current total to zero. Also reverts to normal operating mode when in CAL or FLSH mode.
Hold for 3 seconds to allow changes in calibration/fluid factor (displayed in bottom left). Repeatedly pressing will increment number up
to 19 and then back to zero. When desired number is displayed, press button
Reference Table 1 for specifics.
Hold for 3 seconds to show active flow rate. Press button
while flow rate is displayed.
NOTE: Meter display will automatically turn off after 30 seconds of inactivity. It will turn on when flow resumes or any button is pushed. No data is
lost during periods of inactvity
Changing Unit of Measure
Unit of measure can be changed to ounces (OZ), pints (PT), quarts (QT), gallons (GAL), or liters (LITER) without recalibrating.
2
4
1.
Hold buttons
and
for three seconds. Display will show firmware version.
3
2.
Press button
. Display will show current unit.
3.
To change units, press
2
4.
Press button
to lock in selection. Display will show the firmware version.
5.
To return to normal operating mode, press button
6.
Unit selected will display. Current or accumulated total will update to reflect new unit.
fillrite.com
TT10 IN-LINE TURBINE METER
button repeatedly until desired unit is displayed.
2
again.
2
to lock in new number and return to normal operation.
4
again to resume normal operation. Meter will continue to count volume
INSTALLATION AND OPERATION MANUAL
5
Publicidad
