Cross Tools CAS 600 CN Instrucciones De Uso página 11

Translation of the Original Operating Instructions
3. Usage
This product is designed for private use and not for industrial or commercial purposes or for continuous
operation.
It has been exclusively developed for vacuuming cold ashes from ovens, grills and fireplaces with wood or
pellet combustion. The product is not suitable for oil-fired boilers and fire ovens and also no way for
plaster or cement dust.
4. Scope of delivery
An ash vacuum cleaner, a plastic-coated metal hose, a metal nozzle, a filter, a coarse filter bag, an
instruction manual.
Check the delivery for completeness. Keep the packaging, if possible by the end of the warranty period.
Please dispose of the packing materials in an environmental-friendly manner.
5. Electrical connection
The device has a power cord with plug. Power cord and plug may only be replaced by qualified personnel to
avoid hazards. Do not carry the pump power cord, and do not use it to pull the plug out of the socket. Protect
power plug and power cord from heat, oil and sharp edges
The mentioned values in the technical data must comply with the local power supply. The device
may only be used in the power range, which is mentioned on the nameplate.
Subjecting the equipment before each use a visual inspection. This is especially true for the power
cord and the plug. Pay attention to the soundness of all connections. Damaged appliances must not
be used. In case of damage, the device must be checked by a qualified service.
6. Installation and use
Please also note the pictures are right at the beginning of this manual. The letters, which are mentioned in
the following explanations in brackets refer to these pictures.
6.1. Installation
Before you can take your ash vacuum cleaner into operation, you must configure it only a few simple steps.
The procedure is described as follows:
 Do not place the device on a flat surface.
 Open the ash container (I) by remove the motor head (A). (Fig. 1)
 Take filter, suction hose and the metal nozzle of the container.
 Assemble push the filter (E) by pushing it with even pressure on the intake manifold of the engine head.
 Put the motor head (A) back on the metal tank (I) and close the ash vacuum cleaner. Make sure that the
motor head is properly seated on the container.
 Fit the hose (C) to the suction port in the engine head by inserting one side of the hose into the hole (H)
and lock by turning it slightly to the right.
 Now insert the metal nozzle (D) on the other end of the suction hose.
 Your ash vacuum is now ready!
3
9