Uline H-4017 Manual De Instrucciones página 6

DISPLAY – MOUNTING AND INSTALLATION CONTINUED
OPTIONAL DISPLAY SETUP
To enter setup options, make sure display is unplugged.
Hold down one of the (+) push buttons and plug the
display back in. Release the push button when display
shows "UP."
Set display update delay:
• Display shows "UP" followed by the current delay
time in seconds, (ex. "00"). Press the (+) button to
increase the delay one second at a time.
• After three seconds without pushing the button, the
set display sleep time appears.
Set display sleep time:
• Display shows "SL" followed by the current setting
in minutes. (The display shuts off after a set period
of time with no button pushes.) Press the (+) button
to increase the delay before the display goes into
sleep mode one minute at a time.
• After three seconds without pushing the button, the
display flashes and the number change appears.
PAGE 6 OF 18
(See Figure 16)
1-800-295-5510
1
2
3
4
Set display flashes when number changes:
• Display shows "FL" followed by the current setting
showing number of flashes. Press the (+) button to
increase the number of times the display will flash
when the number changes one flash at a time.
• After three seconds without pushing the button,
the display displays "CS" and saves new settings to
memory.
INSTALLING ADDITIONAL DISPLAYS
• See instructions included with H-2769 or H-4665.
uline.ca
Delay Time (seconds)
Range: 00–29
Sleep Time (seconds)
Range: 00–99
Number of Flashes (when changing)
Range: 00–09
Figure 16
0421 IH-4017