Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND CLEANING
IMPORTANT: Do not immerse the Stand Mixer body in water or other liquids.
1. Turn the Stand Mixer OFF/0 and then Unplug.
2. Wipe the Stand Mixer Body with a soft, damp cloth.
3. The Bowl
is
full dishwasher safe.
The following parts are dishwasher-safe, top rack only: Flat Beater, Flex Edge Beater*,
Double Flex Edge Beater
Scraper*, and Pouring Shield
4. The following part should be hand-washed only, using warm, soapy water and drying
Wire Whip only.
thoroughly:
*Available with select models only and available as an accessory purchase.
TROUBLESHOOTING GUIDE
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
Problem
If Stand Mixer warms up during
use:
If Stand Mixer emits a pungent
odor during initial use:
If the Flat Beater hits the Bowl:
The Speed Control Lever does
not move smoothly or easily:
If your Stand Mixer should fail
to operate, please check the
following:
If product shuts off after
extensive use:
NOTE:
If the problem cannot be corrected, See the "Warranty and Service" section.
Do not return the Stand Mixer to the retailer; retailers do not provide service.
*,
Spiral Dough Hook, 11 Wire
*
.
WARNING
Electrical Shock Hazard
Under heavy loads with extended mixing time periods, you
may not be able to comfortably touch the top of the Stand
Mixer. This is normal.
This is normal. This is common with electric motors.
Stop the Stand Mixer. See the "Product Assembly" section
and adjust the Beater to Bowl Clearance.
To move the Speed Control Lever with ease, lift slightly up
as you move it across the settings in either direction.
Is the Stand Mixer plugged in?
Is the fuse in the circuit to the Stand Mixer in working
order? If you have a circuit breaker box, be sure the circuit
is closed.
Turn off the Stand Mixer for 10-15 seconds, then turn it
back on. If the Stand Mixer still does not start, allow it to
cool for 30 minutes before turning it back on.
Motor has automatic sensor that will keep motor from
overheating by shutting it off. If this occurs, turn speed
switch to Off and let Stand Mixer rest for 30 minutes
before restarting.
Elliptical Whip
*, Pastry Beater*,
Solution
7
Publicidad
