Lenz rcB1200 Manual De Instrucciones página 93

T E C H N I C A L S P E C I F I C A T I O N S
World charger
(with exchangeable plug)
lithium pack insole rcB 1200
F I R S T U S E A N D C H A R G I N G
Important note:
The battery packs must be charged before using them for the first time.
Charging process (world charger)
1. Plug the charger into a socket. The charge indicator (Fig. 2.2) will light up green. Next, plug both
battery packs into the charger. The battery packs can be charged in any operating mode.
2. The charging process begins automatically. The charge indicator (Fig. 2.2) will light up red during
the charging process.
3. Once the batteries are fully charged, the charging process is automatically concluded and the
LED on the charge indicator (Fig. 2.2) will switch back to green.
4. The charging status can be optionally monitored with the Lenz Heat App* convenient control app.
5. Disconnect both battery packs from the charger.
6. After the charger has been charged and unplugged from the battery packs, they are automatically
in the mode which was configured before the charging process was begun. If the battery pack is
not used for any further operations, it will turn off automatically after 12 hours.
Important note:
 The percentage indicator in the Lenz Heat App* may show slightly different
charging statuses during charging mode, as battery packs are subject to production
tolerances by nature. These minimal differences will have no impact on the
product's heating output or heating duration.
 Recharge the battery packs after each use. This extends the service life of the
batteries and ensures that the device is always ready for use.
 The battery consists of lithium ion cells and can be charged in any state. For this
Input: 100 V - 240 VAC
(50/60 Hz), max. 250 mA
– 91 –
Output: 2 x 8.4 V / 450 mA
Output: 7.4 V / 1200 mAh