Lenz rcB1200 Manual De Instrucciones página 96

O P E R A T I N G I N S T R U C T I O N S / E N G L I S H
Changing the heat setting:
 Use the control button (Fig. 1.3) to set 3 different heat settings.
 Every time you push the control button (Fig. 1.3), the heat level rises.
 The respective heat setting is indicated by the flashing of the heat setting display (Fig. 1.2) on the
battery packs.
If there is no sole or charger connected to the battery packs, the battery packs will
automatically switch to POWER OFF mode after 12 hours!
(If you are using the Lenz Heat App* to control your battery packs remotely, the app must also be
closed on your smartphone in order for the battery packs to be able to successfully switch to
POWER OFF mode.)
R E M O T E C O N T R O L
The lithium pack insole rcB1200 battery packs can be controlled via Smartphone Lenz HeatApp* or
via RemoteControl. The batteries must be in "Pairing Mode" to be able to couple them properly with
the Smartphone or the RemoteControl.
Pairing Mode
Please switch the desired batteries to "Pairing Mode". For this purpose, push the control button
(Fig. 1.3.) for approx. 10 seconds until the heat setting displays (Fig. 1.2.) are blinking and then
immediately release the control button. The heat setting display in the middle is flashing constantly.
Note: The Pairing Mode remains active for 2 minutes! If no pairing takes place
during this time, this mode will end automatically!
LED, flashing – standby
LED, steady on – low heating power
LEDs, steady on – medium heating power
LEDs, steady on – high heating power
LED, steady on – Pairing Mode
– 94 –