Publicidad
Idiomas disponibles
Idiomas disponibles
USER GUIDE
OPERATION IN DETAIL
Checking product and supplied package
IMPORTANT!
Risk of damage!
The product can become quickly damaged if you do not take care when opening the packaging with a sharp knife
or other sharp objects.
• Open the packaging very carefully.
1. Remove the product from the packaging.
2. Check that the supply package is complete.
3. Check that the product or individual parts are not damaged. If anything is damaged, do not use the product.
Contact the hotline or e-mail address given in this operating manual.
Starting up the remote control
The scope of delivery includes 1x CR2025 button cell battery for powering the remote control (10). To insert
the battery, proceed as follows:
1. Press the battery slide latch on the bottom of the remote control towards the battery slide.
2. At the same time, pull the battery slide out of the remote control.
3. Insert the button cell battery included in the scope of delivery according to the polarity. The side of the posi-
tive pole is marked on the back of the battery slide.
4. Reinsert the battery slide with the battery into the remote control.
Charging the product
It is recommended to fully charge the integrated battery of the LED module (6) before using the product for
the first time.
IMPORTANT!
Risk of damage!
Charging the product with an unsuitable USB charger may damage the product.
• Only use USB chargers with max. 5 V output voltage for charging.
1. To charge the product, place it on a dry, horizontal surface that is not sensitive to heat.
2. Unwrap the supplied Micro USB charging cable (7) completely.
3. Open the plastic cover on the bottom of the LED module (6).
4. Insert the Micro USB plug into the Micro USB charging socket (9).
5. Insert the USB plug into a suitable USB charger or into an active USB socket (e.g., laptop, computer).
During the charging process, the LED module (6) lights up faintly red.
The charging time is approx. 5 hours.
When the product is fully charged, the LED module (6) doesn't light up anymore.
Then remove the Micro USB charging cable (7) and close the plastic cover.
Inflating the product
Before you can use the RGB LED outdoor stool (1), you must first fill the air cushion (2) with sufficient air.
Proceed as follows:
1. Place the product on a clean place with the bottom side facing upwards and open the air valve (5).
2. Inflate the air cushion (2) via the air valve (5) using an air pump (not included in the scope of delivery). Do
not inflate the air cushion (2) too hard to avoid it bursting during use.
3. Then close the air valve (5).
Do not use a high-pressure compressor for inflation and do not over-inflate the air cushion (2).
12
Publicidad
