Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROLS
GENERATOR SWITCH
Turn the generator switch to the choke position when
starting the engine. Turn the generator switch to the on
position "I" once it has been started. To turn off the gener-
ator, turn the generator switch to the off "0" position.
LCD SMART DISPLAY
The generator is equipped with a multifunction smart LCD
display to monitor real-time power output, fuel usage, and
provide the user with information alerts relating to some
basic service & fault scenarios.
1. Power usage – Up to 6 bars shown with range between
0% and 100% load
2. Indicator symbols – Oil service, overload, low oil level,
low battery voltage
3. Fuel level – Up to 6 bars shown with range between 0%
and 100% fuel level
4. Meter readings - AC voltage, frequency, DC battery voltage,
operating hours*.
*The hours display automatically alternates between two
readings:
a. With arrow showing – remaining hours based on current
load and fuel remaining.
b. Without arrow showing – total accumulated hours
from new.
LOW FUEL LEVEL INDICATOR
When the fuel level drops below 0.3 gal (1.2 L) the first
fuel level bar will flash. If the unit is running, the remaining
hours indicator will count down to 0 hrs before the unit
shuts down. If the unit is started with less than 0.3 gal (1.2
L), the first bar will flash, and the remaining hours will show
0 hrs.
SERVICE INDICATOR
The service indicator will be displayed for 1hr when the
accumulated hours reach the following milestones - 20hrs,
100hrs, and then every 100hrs thereafter.
OVERLOAD INDICATOR
The overload indicator will illuminate when there is a short
circuit in a connected load, or the generator is overloaded.
LOW OIL LEVEL INDICATOR
The low oil level indicator will illuminate, and the unit will
shut down when there is an insufficient amount of oil in the
crankcase
LOW BATTERY VOLTAGE INDICATOR
The low battery indicator will illuminate when the battery
voltage drops below 11.0 volts. The unit may not start
using the electric start, but can still be started using the
recoil start.
14
CONTROLS
Operator's Manual
Publicidad
