Publicidad
Idiomas disponibles
Idiomas disponibles
EN
11.4
CUTTING DEPTH
5
1.
Loosen the depth adjustment knob (5).
2.
Raise or lower the base until the depth scale
reaches the required cutting depth.
3.
Tighten the depth adjustment knob.
11.5
CUTTING WIDTH
1.
Loosen the width adjustment knob (8) to move
the rip-fence (7) to the necessary width.
2.
Tighten the width adjustment knob after
adjustment.
11.6
OPERATE THE MACHINE
@ 45°
8
@ 0°
English
Kickback occurs when the blade stalls quickly and the
machine is driven back to you. A step which pinches
the blade in the wood can cause blade stalling.
To prevent kickback, release switch trigger
immediately if the blade stalls.
1.
Keep the blade at the correct depth position.
2.
Examine the workpiece for nails before you cut.
Do not saw into a nail.
3.
Make straight cuts. Use a straight rip-fence when
rip cutting. This helps prevent you twist the blade.
4.
Use clean, sharp, and correctly set blades. Do
not make cuts with blunt blades.
5.
Support the workpiece correctly before you begin
a cut.
6.
Use stable pressure when you make a cut. Do
not force a cut.
7.
Do not cut warped or wet lumber.
8.
Hold the saw tightly with the two hands and keep
your body in a balanced position to against the
forces if kickback occurs.
7
12
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the
plastic housing or components.
Remove the battery pack from the machine before
maintenance.
12.1
CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks
of electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
10
WARNING
CAUTION
CAUTION
WARNING
CAUTION
Publicidad
