Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
4. Allow the device to heat thoroughly for 10 min to ensure a constant
delivery temperature.
5. When the display is green, the pistol is ready to operate. During first
commissioning, an acoustic signal sounds until a glue stick has been
inserted.
6. Liquid adhesive may drip from the nozzle when the adhesive stick is
already inserted. Therefore, place the device on a suitable surface.
7. Insert the glue stick when the sensor for inserting the glue stick (8) reacts
and the acoustic signal (10) sounds.
LED spotlight - working light
As soon as the working temperature is reached, the LED spotlight switches
on.
If the device is switched off at the On/Off switch (6), the LED spotlight re-
mains lit until the temperature drops below the working temperature.
This makes it easy to see that the device is still hot.
3.3
Setting the stroke limit
The left side of the supporting foot has a switch (4) for adjusting the hot melt
adhesive delivery rate.
• Switch setting „+" for continuous glueing with maximum throughput of hot
melt adhesive.
• Switch setting „-" for small areas, particularly precise glueing with low
throughput of hot melt adhesive.
Fig. 1:
H1079XM_230117.indd 12
Conveying capacity setting
12
GB
24.01.23 10:22
Publicidad
