Teac VRDS-701T Manual Del Usuario página 19

3
Continue to input the numbers for the tracks you
want to program.
4
Press the play/pause (y/9) button on the
remote control or the play (y) button on the
unit to start program playback.
o Skipping, searching and repeat playback functions can be used
during program playback.
NOTE
When "PGM" appears at the top right of the display, what happens
when number buttons are used to input track numbers depends on
the PROGRAM PLAY setting (page 22).
Checking the program order
Press the skip (.//) buttons when playback is stopped to
change the program step shown, allowing the program order to be
checked.
Press the stop (8) button when finished checking.
Changing programmed tracks
Pressing the skip (.//) buttons when playback is stopped
causes the program step to blink, showing the program editing
mode is active.
Press the stop (8) button to end program editing mode.
Inserting tracks
1
Use the skip (.//) buttons when play-
back is stopped to show the program step
where you want to insert a track.
Display example
TRACK 8
8
P02
Program step blinks
2
Use the number buttons to input track numbers.
Display example
TRACK 8
6
P03
o In this example, track number 6 has been added at program
step 3. The tracks on all the following program steps will be
pushed to later steps.
o Continue inputting track numbers to insert multiple tracks.
3
Press the stop (8) button to end editing.
EN
PGM
6:31
PGM
10:41
19