Corsair H60x RGB ELITE Manual De Instrucciones página 9

CONNECT PUMP AND FANS TO MOTHERBOARD
> Connect pump tach cable to the CPU_FAN header on your motherboard (Figure 1).
> Connect each fan to the Y-splitter cable (J) then plug the Y-splitter cable into a 4-pin header on your
motherboard (Figure 2).
CONNECT PUMP AND FANS TO ARGB
> Connect the pump and fans into the ARGB cable (I). For best lighting playback, connect the pump into
connector #1 and the fan(s) on connector #2 and #3. Plug the ARGB cable into the ARGB header on a
compatible motherboard.
1
3
Note: The pump and fan LEDs get power from the motherboard or control device. If they are not
connected, they will not illuminate.
> Alternatively, for the full iCUE experience, connect the 4-pin fan and 4-pin RGB headers into the "Fans" (A)
and "RGB HUB" (B) headers on an iCUE COMMANDER CORE XT (sold separately).
ENGLISH
3-PIN
Figure 1
V5+
D
DNG
2
6 5
Figure 2
B
FANS
4 3 2 1
A
7