Sentry Fire-Safe GF Serie Manual De Instrucciones página 6

Programming a user PIN
1. Press the Program key.
2. Press it a second time.
3. Enter your 5-digit User Code. The green LED
remains ON.
4. Enter the 5-digit User PIN of your choice (any combina-
tion except 00000.) After 5 digits are entered, the green
LED turns OFF.
(To enter a new User PIN, repeat these steps. To erase the
User PIN, press Program twice, enter your User Code and
then enter 00000.)
Battery replacement
When old batteries are removed for replacement, your
User PIN will be voided; only Factory and User Codes will
work. To reestablish your User PIN, follow the directions
above under "Programming a User PIN".
Key override
If your electronic lock fails or you do not have any codes
available, you may use a key override to access this unit.
1. Remove the battery cover, disconnect and remove the
battery holder.
2. Insert the skeleton key into the key hole inside the
opening for the battery.
3. Turn the key to the right.
4. Open the door.
Signals
Your electronic-lock safe communicates using several
audio/visual signals.
Red (Error) LED + three beeps indicates
one of the following:
1. You have pressed Program key out of sequence
2. You have entered an invalid code or User PIN.
3. You have let 5 seconds or more elapse between key
entries.
Green (Proceed) LED + single beep occurs
1. After entering each digit of Factory or User Code,
or User PIN
2. After pressing Clear key
3. After pressing Program key
Green LED only
1. Comes ON after you enter a valid code/User PIN and
remains lit during the 4-second period in which the safe
can be opened.
2. Comes ON in the Program User Code mode after you
enter the Factory Code and remains lit until you have
finished entering a 5-digit User Code.
3. Comes ON in the Program User PIN mode after you have
entered your User Code and remains ON until you have
entered a 5-digit User PIN .
6
Questions?
®
Yellow LED
Indicates "low battery" and will typically turn ON if battery
has been in use approximately two years or longer.
Your electronic lock automatically performs a low battery
test during each lock use.
If a "low battery" condition is detected the Yellow LED will
come ON and remain ON during each subsequent lock
operation. (The lock will continue to function in a Low
Battery state, until battery failure.) The Yellow LED will turn
OFF only after three consecutive "Good Battery" readings
or after the low batteries are replaced. (Note: If the new
batteries are installed in less than 60 seconds the Yellow
LED may come ON and stay ON during the first lock
operation before it returns to OFF.)
NOTE: It is recommended you replace the batteries
after two years, or when the yellow LED
remains on.
Delay mode
The lock automatically enters a two-minute Delay Mode
after an invalid code has been entered three consecutive
times. In this mode, the lock can not be activated and any
key entry will generate an ERROR signal.
Lost keys or combination
First, find your safe's Serial Number. The Serial Number
is printed on the small label on the right side of the safe
(outside). Send this and a check or money order for $8.00
(U.S. funds) ($8.00 for keys and $8.00 for combinations).
Payment may also be made using your VISA or Mastercard
credit card. Please include a written statement of ownership
witnessed and signed by a notary public or bank official. The
notary must have a different last name than the owner. Mail
to: Sentry Group, Dept. 200, 882 Linden Avenue, Rochester,
NY 14625-2784, USA.
Sent585-381-4900 8 am – 9 pm E.S.T. , M–F..
Questions?
Call Sentry Customer Service: 1-800-828-1438 or
585-381-4900 8 am – 9 pm E.S.T. , M–F.