Publicidad
Top mount (V120)
Once the place has been selected, cut-off a mounting gap using the templates included.
Place the control in the resulting gap without the top cover and adjust as required.
Before marking the holes, put back the top cover to check the position of the control is well cen-
tered and the gap fully covered.
Mark the holes, set aside the control and make the holes with a 6 mm drill.
Clean the area and install firmly the control on the console with the screws provided.
Install the control lever on its position with the included screw. It is highly recommended to use
some thread glue (e.g. Loctite® 243) on the lever screw.
Verify the correct functioning by operating the lever ahead and astern and in warming mode.
Set the cables as shown in "3.Cable connection".
Adjust the lever friction as shown "7.Friction adjusting".
Use some lubricant in order to keep the mechanism lubricated.
Install the top cover.
Lateral mount (L120)
Once the place has been selected, cut-off a mounting gap using the templates included.
Place the control in the resulting gap without the front plate and adjust as required.
Install the front plate, mark the holes and set aside the control for drilling.
Make the holes with a 6 mm drill.
Fix the front plate on the control frame by setting the screws around the control axis.
Fix the control to the console with the included screws.
Install the control lever on its position with the included screw . It is highly recommend to use some
thread glue (e.g. Loctite® 243) on the lever screw.
Make sure that all four screws are eually and proportionally thighten, this will avoid an unbalance axis
which could result in undesirable frictions or malfunctions in the control.
Verify the correct functioning by operating the lever ahead and astern and in warming mode.
Set the cables as shown in "3.Cable connection".
Adjust the lever friction as shown "7.Friction adjusting".
Use some lubricant in order to keep the mechanism lubricated.
Install the top cover.
Attention!
5
Publicidad
