KEKAI KTP2080 Manual De Instrucciones página 20

4).Press" "button,the display shows P1 as default, press"
period (P1-P6 ）.
Note :It can only set maximum 6 time periods for each working day,while setting any time
and adjust temperature. Follow step 5-7 below to set turn-on time/turn-off time/desired
temperature for each time period(P1-P6）. Such as setting P1: (Fig. 11)
(Fig. 11)
5).Press" " button,the display shows "00"as default. Press"
increase one hour to set the turn-on time (00-24 hours). Such as set the turn-on time 7:00
am (As figure );(Fig. 12)
6).Press" " button,the display shows the previous turn-on time by default. Press
" " button one time increase one hour to set the turn-off time (00-24 hours).
The" "can not be less than"
product enter into standby mode; Such as set the shutdown time at 13:00 pm: (Fig. 13)
7).Press" /
8). Repeat steps 3-7 above, you can set the weekly program for the working day you want.
9).Then press" " button to confirm the setting.
10). To cancel the weekly program function, press the "
go off. The weekly program is off.
Note:
-After the above setting are completed and P program is working,press"
check set working day (d1-d7),press"
" button to check the set turn-on time,press"
" button to set the target temperature(Temperature range 10-49℃);
(Fig. 12)
";When the" " is the same as"
" button again , the light "P" will
" button to check time period (P1-P6), press"
"button to check the set turn-off time.
"button to set time
(Fig. 13)
" button one time
", the
"button to