Precautions For Use; Product Registration - Teac TN-300 Manual Del Usuario

Precautions for use

o Do not place anything on the turntable cover. Objects
on the cover might cause noise due to vibrations or
fall off, especially during playback.
o Avoid placing the unit in direct sunlight, close to a
source of heat or in other similar conditions. Do not
place the unit on top of an amplifier or other equip-
ment that might generate heat that exceeds the
operating temperature range of this unit. Doing so
could cause discoloration, deformation or malfunction.
o As the unit could become warm during operation,
always leave sufficient space around it for ventilation.
When installing this unit, leave a little space (at least
20 cm (8")) between it and other devices and walls to
allow good heat dissipation.
When placing it in a rack, for example, leave at least
35 cm (13 3/4") open above it and 10 cm (4") open
behind it. Failure to provide these gaps could cause
heat to build up inside and result in fire.
o DO NOT MOVE THE UNIT DURING PLAYBACK. During
playback, the record rotates. Do not lift or move the
unit during playback. Doing so may damage the
record, the stylus, the cartridge or the unit.
o Always remove the record before relocating or mov-
ing this unit. Moving the unit with a record on the
turntable could damage the record, the stylus and
the cartridge or could cause a malfunction.
o The voltage supplied to the unit should match the
voltage as printed on the rear panel. If you are in any
doubt regarding this matter, consult an electrician.
6
Before use (continued)
Maintenance
If the surface of the unit gets dirty, wipe it with a soft
cloth or use diluted mild liquid soap. Allow the surface
of the unit to dry completely before using.
o Do not use chemical cleaning cloths, thinner or simi-
V CAUTION
For safety, disconnect the power cord from the socket
before cleaning.

Product registration

Customers in the USA, please visit the following TEAC
website to register your TEAC product online.
lar substances as they could damage the surface of
the unit.
http://audio.teac.com/support/registration/