jcm-tech BOX-DCS Manual De Instrucciones página 4

Programming vía additional radio transmitters without "master transmitter"
(pin-mode)
In order to operate in this mode, it is necessary to first insert an installation "PIN". This "PIN" is a fourdigit number, which is
inserted, by means of a MANAGER+DCS or MINIMAN+DCS, into the first transmitter which is recorded in the receiver or dir-
ectly onto the memory card. To record the "PIN" into the receiver, press the programming pushbutton during 1s, a long acous-
tic signal will indicate it has entered the programming mode. Continue pressing during 4s more, and a long intermittent
acoustic signal will indicate that the memory has been erased. Continue pressing the pushbutton and now you can press the
transmitter. Then, two short acoustic signals will indicate the exit of the programming mode. As from now, the receiver will
recognize this "PIN" in any transmitter inserted. This "PIN" will be emitted pressing the pushbutton of the rear part of the
respective transmitter, and automatically, the receiver will store it in his memory with a long acoustic signal.
Deletion of memory
A code cannot be deleted individually (except if a MANAGER+DCS or MINIMAN+DCS is used).
It can only be eliminated by performing a "system reset". To erase the memory, press the programming button for 5 seconds.
A long "beep" will indicate that the unit has entered the programming mode. After the 5 seconds, the unit will emit a series of
intermittent "beeps", indicating that the memory is free and that the receiver is in the programming mode. The installation PIN
will remain operative, in case you are using PIN-MODE.
Note: in the hypothetical event of the receiver memory being affected by some unusual external factor, the unit will emit an
intermittent acoustic signal when the transmitter is pressed.
Code replacement
This function enables you to cancel any lost or robbed transmitter, smart card or proximity key, without the necessity of hav-
ing the receiver present. By means of a MANAGER+DCS or MINIMAN+DCS and knowing the code, you can change the
"Replacement Number", from "0" to "7" for transmitters (0 is the first remote control delivered by the factory, and 7 the last
"replacement" before setting the code as obsolete in the installation). In the case of smart cards or proximity keys, this func-
tion can only be activated with the MANAGER+DCS portable programmer, and goes from "0" to "3". Therefore, it is only pos-
sible to carry out 3 more replacements starting from the original card or key. The system permits such "replacements" from a
new smart card or proximity key, changing the code and "Replacement Number" (see MANAGER+DCS portable pro-
grammer manual). Emitting the code to the receiver, the new replacement number will cancel the previous one and will be
automatically updated. In the installation, the user must activate the transmitter twice. The first time, the receiver updates the
new element and cancels the previous one. The second time, the receiver activates the corresponding operation in the
receiver. In case of access control elements such as smart cards and proximity key, the user will only have to activate once
and both actions will be realised at the same time.
Using the receiver card
This receivers are designed for the remote control of garage doors, to send the activation commands to control panels in
which the card is inserted. Its use is not guaranteed for directly activating units other than those specified. The manufacturer
reserves the right to modify the equipment specifications without notification.
Important annex
In compliance with the European Directive low-voltage electrical equipment, we hereby inform users of the following require-
ments: for units which are permanently connected, an easily accessible circuitbreaker device must be built into the wiring sys-
tem; this unit must always be installed in a vertical position and firmly fixed to the structure of the building; this unit must only
be handled by a specialised installer, by his maintenance staff or by a duly trained operator; the instruction manual for this
unit must always remain in the possession of the user; terminals of maximum section 3,8mm2 must be used for the power
supply connections.
jcmtechnologies
4