Rollplay FLEX KART Manual Del Usuario página 7

EN
Attention
1. Vehicle must not be used on roads, pavements, slopes or
sand.
2. Vehicle should be used on a flat surface.
3. Do not overload the vehicle. Please take note of the
weight restrictions: Maximum total weight 25 Kg .
4. Battery charging must be performed by an adult.
5. Children riding this vehicle should be supervised at all
times by a responsible adult.
6. Do not charge the circuit of the vehicle or its attaching
electric equipment.
7. Do not ride in water or any other fluids.
8. Come to a stop when approaching an obstruction, turn
away and use the vehicle elsewhere.
9. Please charge once the vehicle runs slowly otherwise
life-span of battery will be reduced.
10. Please charge the battery in full before storing it for
long periods of time, then recharge it every 3 months to
prolong the battery life.
11. Do not ride in the rain.
12. Battery, charger, electric wire, plug, enclosure and other
parts should be periodically check for damage, if damage is
found, discontinue use until repaired.
13. Charger used with the toy are to be regularly examined
for damage to the cord, plug, enclosure and other parts,
and that, in the event of such damage, the toy must not be
used with this chager until the damage has been repaired.
14. This vehicle is unsuitable for children under 5 years old
due to its maximum speed.
15. The vehicle must only use with the recommended
charger.
16. The charger is not a toy.
17. Clean with a damp cloth only.
18. Check components are in good condition, if not, repair
or replace them.
19. Protective equipment should be worn, not to be used in
traffic.
20. Exhausted batteries are to be removed from the toy.
21. Rechargeable batteries are to be removed from the toy
before being charged.
Assembly instructions
1. Unfold the Frame
1). Take the vehicle out of the package.
2). Unlock the frame by pulling the Frame Lock out, away from
the vehicle. (Fig A)
3). Raise the Steering Bar until it clicks into place (Fig B).
2. Install Steering Wheel
1). Remove the screw (M5*47) from the Steering Wheel.
2). Plug the steering wheel wire into the steering bar wire. (Fig
A)
3). Place the steering wheel onto the top of the steering bar,
match the screw holes of the steering wheel and the
steering bar.（Note: Gently tuck the wires completely into
the steering bar, to avoid damage to the wires.）
4). Insert the screw (M5*47) into the hole and fasten with the
nut to secure.(Fig B)
3. Attach the Seat
1). Remove screws (M6*38) from the the polybag for the seat.
2). Align the two holes on the Seat over the holes on the vehicle
body to the desired position. Insert the screws through the
holes on the seat and the frame, tighten with a Phillips
Screwdriver is one word.
Note: There are two length options. We suggest
moving the seat back to the second position, once
your child outgrows the shorter length.
4. Folding Instructions
1). Hold down the Lock Button and squeeze the spring
bolts(Fig. C) and slide the frame and steering bar down,
toward the seat (Fig. E).
2). Check to ensure the frame lock is locked securely.
Note: Only adults should fold and unfold the vehicle
to avoid potential injury.
OPERATING INSTRUCTION
5. Operating Instructions:
Press the Power Button on the Steering Wheel to move the
vehicle. Release the Power Button to stop.
6. To Charge the Battery:
1). Ensure the FLEX Kart is stopped and turned off.
2). Locate the seat lock at the front of the seat. Using a coin or
screwdriver turn the seat lock to the unlocked position and
remove the seat.
3). Unplug the red battery connector (A) from the red engine
connector (B).
4). Connect the red battery connector (A) to the red battery
charger connector (C) and plug (D) into a 120 V outlet.
7. To Reconnect Battery:
1. Unplug the battery charger (D) from the outlet.
2. Unplug the red battery connector(A).
3. Reconnect the red battery connector (A) to the red engine
connector (B).
4. Replace the seat and tighten lock.
6