MSW Motor Technics MSW-HS-F1000 Manual De Instrucciones página 21

Align the smaller holes in the pedal unit profiles with the lever profiles from the
inside with the spring, insert 2 pins and secure them at the ends with clips (see
picture below), bend the ends of the clips.
After installing the pedal unit, attach the 2 front brackets from the front by
screwing them to the table top. Use the screws and washers provided with the
table top - use the included wrenches.
From the back, insert the rear brackets into the holes so that the measure on them
is at the top and mount a metal crossbar on these brackets with the help of
mounting elements (d) and washers (e) for the screws.
3.3.
Working with the machine
• If necessary, adjust the distance of the crossbar to the sheet (pay attention
to the scale on the brackets), i.e. loosen the screws, adjust and tighten
them again.
Insert a piece of a flat sheet. With large sheets of material, place it so that,
•
if necessary, the rest is rested on the supports.
Place it so as to make the desired cut - hold the piece with both hands.
•
• Press the blade lever pedal firmly with your foot until it makes a complete
stroke.
NOTE: sometimes in the case of thicker and/or harder materials, it may be
necessary to press the pedal more or even stand on it.
3.3.3 Blade clearance adjustment