Dolmar ES-154 Manual De Instrucciones página 10

................. Caution: kickback!
................ Protect against rain and damp!
................ Wear a helmet, goggles and ear
protection!
................ Wear safety gloves!
................ Withdraw the mains plug!
................. First aid
........ Maximum permissible length of cut
........ Always use two hands when operating
the chain saw.
................ Beware of chain saw kickback and avoid
contact with bar tip.
........ Direction of chain travel
.................. Chain oil
.......... Chain brake released
.......... Chain brake applied
................ Prohibited!
............... Only for EU countries
Due to the presence of hazardous
components in the equipment, used
electrical and electronic equipment may
have a negative impact on the
environment and human health.
Do not dispose of electrical and
electronic appliances with household
waste!
In accordance with the European
Directive on waste electrical and
electronic equipment and its adaptation
to national law, used electrical and
electronic equipment should be collected
separately and delivered to a separate
collection point for municipal waste,
operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
.............. Guaranteed sound power level according
to EU Outdoor Noise Directive.
.............. Sound power level according to Australia
NSW Noise Control Regulation
Intended use
The tool is intended for cutting lumbers and logs.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
10
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Chain saw safety warnings
1. Keep all parts of the body away from the saw
chain when the chain saw is operating. Before you
start the chain saw, make sure the saw chain is
not contacting anything. A moment of inattention
while operating chain saws may cause entanglement
of your clothing or body with the saw chain.
2. Always hold the chain saw with your right hand on
the rear handle and your left hand on the front
handle. Holding the chain saw with a reversed hand
configuration increases the risk of personal injury and
should never be done.
3. Hold the chain saw by insulated gripping surfaces
only, because the saw chain may contact hidden
wiring or its own cord. Saw chains contacting a "live"
wire may make exposed metal parts of the chain saw
"live" and could give the operator an electric shock.
4. Wear eye protection. Further protective equipment
for hearing, head, hands, legs and feet is
recommended. Adequate protective equipment will
reduce personal injury from flying debris or accidental
contact with the saw chain.
5. Do not operate a chain saw in a tree, on a ladder,
from a rooftop, or any unstable support. Operation
of a chain saw in this manner could result in serious
personal injury.
6. Always keep proper footing and operate the chain
saw only when standing on fixed, secure and level
surface. Slippery or unstable surfaces may cause a
loss of balance or control of the chain saw.
7. When cutting a limb that is under tension, be alert
for spring back. When the tension in the wood fibres
is released, the spring loaded limb may strike the
operator and/or throw the chain saw out of control.
8. Use extreme caution when cutting brush and
saplings. The slender material may catch the saw
chain and be whipped toward you or pull you off
balance.
ENE085-1
9. Carry the chain saw by the front handle with the
chain saw switched off and away from your body.
ENF002-2
When transporting or storing the chain saw,
always fit the guide bar cover. Proper handling of
the chain saw will reduce the likelihood of accidental
contact with the moving saw chain.
GEA010-2
GEB037-9