Publicidad
Idiomas disponibles
Idiomas disponibles
to the compressed air shut-off valve. Ensure that the pressure of the air supplying
the device does not exceed the recommended range.
ASSEMBLY OF THE DEVICE
After filling the gun's container with the paint material, the female compressed air
¼ tip (coupler) can be connected to the male tip of the device.
IMPORTANT: the device can be supplied only with compressed air, no other gases
can be used. The supplied air should be dry and clean - a filter with a dryer should
be installed in the compressed air system.
3.3.
Cleaning and maintenance
a)
The product should be cleaned after each use, if it is not going to be used again.
The varnish spray gun should be disassembled and its elements thoroughly
rinsed, e.g. in a nitro solvent. Blow out the elements with compressed air after
cleaning.
b)
Use only non-corrosive agents for cleaning the surface.
c)
After each cleaning, all components should be well dried before the device is
used again.
d)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
e)
Use a soft cloth and a brush for cleaning.
f)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the device.
DISPOSAL OF USED DEVICES
At the end of its service life, this product must not be disposed of with normal
household waste, but should be taken to a collection point for the recycling of
electrical and electronic devices. This is shown by the symbol placed on the
product, operating manual or the packaging. The materials used in the device can
be reused according to their intended use. By reusing materials or conducting
other forms of using used devices, you make a significant contribution to the
protection of our environment.
Local administration will provide you with information about the appropriate
point for disposal of used devices.
Publicidad
