Publicidad
Idiomas disponibles
Idiomas disponibles
Intermittent, fluttering
Too much paint in the
middle
Shaped like a cone
Split
3.4.
Cleaning and maintenance
a)
Pull out the mains plug before each cleaning and when the device is not in use.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the device is used
again.
1. Air enters between
the paint nozzle and
the conical seat of
the body of the gun.
2. Air enters through
the paint suction
tube from the
container.
3. Air enters through
the
connection
between
container and the
gun.
1. Paint viscosity too
high.
2. Paint flow set too
low.
Paint collects on the air
nozzles partially
blocking them, so that
the air flow is different
on each nozzle.
1. Paint viscosity too
low.
2. Paint viscosity set
too high.
1. Clean the paint nozzle
seat
-
replace the nozzle.
2. Tighten
suction tube.
3. Tighten/repair the seal
on
the
between container and
the
gun.
1.
Thin the paint.
2.
Increase
throughput with the
knob.
Remove the paint from the
nozzles, but do not use any
metal objects to clean the
nozzle openings.
1. Add ink to the container
to increase its viscosity.
2. Turn the knob to reduce
the ink throughput.
if
damaged,
the
paint
connection
paint
Publicidad
