Husqvarna FS400LV Manual De Usuario página 13

10. Install the cutting blade on the inner flange (F).
E
D
11. Make sure that the cutting blade rotates in the
direction of the arrows shown on the cutting blade.
CAUTION:
cutting blade if it is installed opposite the
direction of rotation.
12. Install the blade flange (E) and the blade screw (D).
Make sure that the locking pin (G) on the inner
flange, goes through the cutting blade and into the
blade flange (E).
13. Hold and push the cutting blade in reverse direction
of rotation. At the same time tighten the blade screw
(D).
14. Turn the cutting depth wheel counterclockwise to
lower the cutting blade.
15. Tighten the blade screw (D) to minimum 40-45 Nm
with the supplied wrench. The resistance between
the cutting blade and the ground keeps the cutting
blade in position.
16. Lower the blade guard.
17. Start the product and listen for unusual sounds. If
there are unusual sounds, remove the cutting blade.
a) Examine the cutting blade for damages.
b) Install the cutting blade again. Replace the
cutting blade if it is damaged.
1852 - 001 - 25.11.2022
F
G
Risk of damage to the
To remove or replace the cutting blade
WARNING:
diamond blades, let the product become
cool and use protective gloves. Diamond
blades are very hot after use.
1. Make sure that the engine ON/OFF switch is in its
OFF position.
2. Stop the water supply and disconnect the water hose
from the blade guard.
To install a cutting blade on page 12
3. Do the steps in
to remove or replace the cutting blade.
4. Before you operate the product again, start the water
supply and connect the water hose to the blade
guard.
To set the cutting depth indicator
WARNING:
depth wheel when the cutting depth wheel
is not in use.
1. Turn the cutting depth wheel until the cutting blade
slightly touches the ground. Push the lever to lock
the cutting depth wheel.
CAUTION:
blade too quickly. If the cutting blade
hits the surface with force, it can cause
damage to the cutting blade.
When you remove
Always lock the cutting
Do not lower the cutting
13