FAFREES FF20 Manual De Instrucciones página 6

Function introduction:
1. Charging: The charging port of the battery at the saddle position is on the right side above
the battery, and the charging port of the battery on the front is on the left side above the
battery. When the battery is fully charged, the charger light changes from red to green.
2. Power On/Off: Long press the power button to turn on/off the display power.
3. Display: After the display is turned on, briefly press the power button (<0.5s) to see the
different trip modes. The information displayed will be switched between the daily
kilometers (TRIP) - total kilometers (ODO) - Maximum speed (MAX) - Average speed (AVG)
- Remaining distance (RANGE) - Energy consumption (CALORIES) - Output power
(POWER) - Travel time (TIME).
4. Headlight: By pressing and holding the light button, the controller will turn on/off the
headlight.
5. PAS Mode: You must turn on the battery to use the e-bike in pedal-assisted mode. Power
assist is triggered when you pedal forward, and stops when you stop pedaling, sometime
with a delay. If no power is needed, turn off the power of the battery.
6. Electric Mode: You do not need to pedal the e-bike if you use the hand throttle. The
throttle can be controlled by twisting it from the resting position, and the farther the throttle
switch is from resting position, the more power is sent to the motor to accelerate the e-bike.
7. Cruise Control : Cruise control will be triggered when you holding thumb throttle and
riding at the same speed for 8 seconds, and it will be released by braking/pedaling or
throttling.
8. Walk Assist Mode: Long press the "-" button, the electric bicycle will enter the walk assist
mode. The electrical bike runs at a constant speed of 6 km/h. Release the "-" button, the
electric bicycle will immediately stop power output and return to the state before push.
3