Convair MAGICOOL Manual Del Propietário página 5

Safety
When using electrical appliances please
follow these precautions to reduce the
risk of fire, electrical shock and injury to
persons.
Warning ! This appliance is not intended for
use by young children or infirm persons
without supervision.
Do not use this appliance in a closed room
when only occupied by children.
Caution! Before connecting your Convair
cooler to an electrical outlet, check that the
required voltage shown on the rating label is
the same as your power supply.
To avoid accidents and fire hazards, keep
the cord out of heavy traffic areas, never put
near heat registers, radiators or stoves. Do
not use this appliance if the plug or cord is
damaged.
Caution! Do not plug in the cord with wet
hands as electric shock may result.
This appliance is designed with a safety
feature so that if the rear panel is removed
the appliance will not operate. Do not
attempt to defeat this safety feature.
Use this appliance for the intended use only.
Do not use this appliance outdoors.
Caution! Your Convair cooler
holds water so be sure to move it carefully.
Do not move the appliance when it is
full of water - it is advisable to move it into
position before filling it.
Caution! Always switch your Convair
cooler off and unplug it before filling it with
water, cleaning it or servicing the appliance.
At the end of each season, or at least
monthly if heavily used, it is advisable to
carry out some simple maintenance on your
Convair cooler. Refer to the Maintenance
section.
All manuals and user guides at all-guides.com
English
To attach the handle, push it into the slot at
the back of the appliance until it clicks into
place. The handle has been designed to be
a permanent addition to the appliance. Do
not attempt to remove it once assembled.
The handle will make moving the appliance
easier.
The flip-out foot can be used to increase the
angle of the air flow.
Hold the cooler firmly at the top and lean it
slightly backwards. Locate the foot at the
bottom of the tank and pivot it forward until it
locks into place. Return the cooler to its
upright position, so it is resting, at the front,
on the flip-out foot. You should now notice
the cooler angled back slightly increasing
the height of the air flow.
03
Handle Assembly
Flip-out foot
02
01