Craftsman 675 Serie Manual Del Operador página 17

HYDRAULIC FLUID AND INLET FILTER
WARNING
Stop the engine and relieve hydraulic system pressure before chang-
ing or adjusting fittings, hoses, tubing, or other system components.
Check the hydraulic fluid level in the log splitter reservoir tank before
each use. Maintain the fluid level within the range specified on the
dipstick at all times.
Change the hydraulic fluid in the reservoir every 100 hours of opera-
tion. Follow the steps below:
1. Disconnect the suction hose from the bottom of the reservoir tank.
2. Carefully unthread the inlet filter and clean it with penetrating oil.
See Figure 17.
3. Allow the fluid to drain into a suitable container.
4. Reinsert the filter and refill the reservoir. Approved fluids include
Shell Tellus® S2 M 32 Hydraulic Fluid, Dexron® III / Mercon
automatic transmission fluid, Pro-Select™ AW-32 Hydraulic Oil or
10WAW-ISO viscosity grade 32 hydraulic oil.
5. Maintain the fluid level within the range specified on the dipstick
at all times.
NOTE: Always dispose of used hydraulic fluid and engine oil at
approved recycling centers only.
Contaminants in fluid may damage the hydraulic components. Flushing
the reservoir tank and hoses with kerosene whenever service is
performed on the tank, hydraulic pump or valve is recommended. Any
repair to the hydraulic components should be performed by a Sears
Service Center.
WARNING
Use extreme caution when working with kerosene. It is an extremely
flammable fluid.
SERVICE AND MAINTENANCE
Figure 17
Hydraulic Filter
Change the hydraulic filter every 50 hours of operation. Use only a 10
micron hydraulic filter. Order part number 723-0405.
BEAM AND SPLITTING WEDGE
Before each use, lubricate both sides of the beam (where it comes into
contact with the splitting wedge) with engine oil. The wedge plate on
the log splitter is designed so the gibs on the side of the wedge plate
can be removed and rotated and/or turned over for even wear.
Make certain to readjust the adjustment bolts so the wedge moves
freely, but no excess space exists between the wedge plate and the
beam.
ENGINE
Check Engine Oil
1. Stop the engine and wait several minutes before checking the oil
level.
2. Remove the oil fill dipstick.
3. Check the oil level on the dipstick. With the engine on level
ground, the oil must be to the FULL mark on the dipstick.
4. Replace the dipstick and tighten.
Changing Engine Oil
Refer to 1-800-4MY-HOME to schedule service.
Service Air Filter
The air filter prevents damaging dirt, dust, etc., from entering the
carburetor and being forced into the engine and is important to engine
life and performance.
Never run the engine without an air cleaner completely assembled.
Service the cartridge every 25 operating hours or every season.
Service the cartridge more often under dusty conditions.
To Service Air Filter
1. Loosen the air filter cover screw, but do not remove the screw
from the cover. Swing the cover down to remove from the hinge.
2. Inspect the filter for discoloration or dirt accumulation. If either is
present, proceed as follows:
a. Clean the inside of compartment and cover thoroughly and
remove the cartridge.
b. Reassemble the new cartridge in the compartment. Swing
the cover down and tighten the screw loosened earlier.
Temperature of muffler and nearby areas may exceed 150˚ F(65˚C).
Avoid these areas.
17
WARNING
WARNING