Cramer 82PST39 Manual De Instrucciones página 4

EN
1 DESCRIPTION
1.1 PURPOSE
The product fitted with a cutting attachment mounted on a
pole to enable the operator to cut the branches of standing
trees but not intends for cutting woods as normal chainsaw.
This appliance is not intended for use by persons (including
children) with reduced understanding, or lack of experience
and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
1.2 OVERVIEW
Figure 1-20.
Lock-out button
1
Small lock-out button
2
Trigger
3
Auxiliary handle
4
Pole saw handle
5
Carrying ring
6
Screw cap
7
Extension pole
8
Pole saw head
9
10 Chain cover
11 Guide bar
2 GENERAL SAFETY
WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this machine. Failure to
follow all instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
12 Saw chain
13 Oil tank cap
14 Oil indicator
15 Bar groove
16 Cutter
17 Chain drive links
18 Sprocket
19 Chain tension pin
hole
20 Chain cover lock nut
21 Chain tension screw
WARNING
WARNING
English
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain lubricant as follows.
Use bar and chain lubricant that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt enters
in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. A completely filled oil tank will last for 15 - 40 minutes
operating time.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
3.3 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 10-14.
1. Remove the battery pack from the machine.
2. Remove the chain cover nuts with the wrench.
3. Remove the chain cover.
4. Put the chain drive links into the bar groove.
5. Put the chain cutters in the direction of the chain
operation.
4
WARNING
IMPORTANT
NOTE
IMPORTANT