Cramer 82PST39 Manual De Instrucciones página 5

6. Put the chain in position and make sure that the loop is
behind the guide bar.
7. Hold the chain and bar.
8. Put the chain loop around the sprocket.
9. Make sure the chain tension pin hole on the guide bar fits
correctly with the bolt.
10. Install the chain cover.
11. Tighten the chain. Refer to Adjust the chain tension.
12. Tighten the nuts when the chain is well tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. After that, examine the tension again and
tighten the chain if necessary.
3.4 USE THE SHOULDER STRAP
Figure 4.
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
3.5 ADJUST THE LENGTH OF THE
POLE SAW
Figure 3.
1. Loose the collar by turning it counterclockwise.
2. Pull the extension pole upward or backward to adjust the
length of the pole saw.
3. Tighten the collar.
3.6 ADJUST THE ANGEL OF THE
POLE SAW HEAD
The pole saw head has two angels：0° or 90°，the pole saw
can cut vertically or horizontally.
Figure 6.
1. Loose the two screws on the pole saw head with the
wrench.
2. Turning the pole saw head 90° until the screws fit into the
screw holes on the pole.
3. Tighten the screws.
3.7 CUTTING PREPARATION
Figure 4.
Before you start to cut, make sure that
• Wear heavy gloves for maximum grip and protection.
• Maintain a proper grip on the machine during operation.
• Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
NOTE
English
• Keep your body to the left of the chain line.
• Never use a left-handed (cross-handed) grip, or any
stance that places your body or arm across the chain
line.
• Never stand directly under the limb you are cutting.
• Periodically examine the tightness of the collars during
operation.
3.8 INSTALL THE BATTERY PACK
Figure 5.
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.9 REMOVE THE BATTERY PACK
Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Remove the battery pack and keep hands clear of the lock
out button when you move the machine.
Examine the chain tension before each use.
4.1 EXAMINE THE CHAIN
LUBRICATION
Do not use the machine without sufficient chain lubrication.
Figure 2.
1. Examine the lubricant level of the machine from the oil
indicator.
2. Add more lubricant if it is necessary.
4.2 START THE MACHINE
Figure 7.
5
WARNING
NOTE
IMPORTANT
NOTE
EN