Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Service:
- The appliance has been oiled in ori-
gin. In order to maintain the applian-
ce in a good operation conditions we
suggest greasing the blades every
time you clean it by putting a few
drops of oil on the ends of the blade,
and finally switching on the appliance
during a few seconds.
- Make sure that the appliance is
serviced only by specialist personnel,
and that only original spare parts
or accessories are used to replace
existing parts/accessories.
- Any misuse or failure to follow
the instructions for use renders the
guarantee and the manufacturer's
liability null and void.
Charging the battery
Caution: A new battery is not fully
charged and must therefore be char-
ged before the appliance is used for
the first time.
- Charge the battery at an atmosphe-
ric temperature of between 4 and
40ºC.
- Plug the charger (K) into the mains.
- Approximately 10 to 12 hours are
needed for a complete charge of the
battery. Never attempt to over charge
the battery (although it is recommen-
ded that the first charge of the battery
be of 14 hours in duration).
- Connect the charger (K) to the jack
using the socket on the appliance.
The socket is located at the lower/
back part of the appliance.
- The pilot light will come on to
indicate that the charger is charging
the battery.
-- When the battery is charged dis-
connect the charger from the mains
supply.
NB: For a long battery life, it is
advisable to charge the battery, only,
when it has run out completely.
Instructions for use
Before use:
- Before using this product for the
first time, it is important to make a
full charge of batteries.
- Prepare the appliance according to
the function you wish to use:
Insertion of comb guide:
- Take the comb guide for both ends
and insert in the guidelines at the
sides of the appliance until it fits
properly (Fig.1).
- To extract the comb guide, just
pull out.
Use:
- The appliance can be used directly
connected to the mains, or by using
his batteries.
- Unroll the cable completely before
plugging it in.
- Ensure that the electronic connector
is properly attached to the appliance.
- Connect the appliance to the mains.
- Turn the appliance on, by using the
on/off switch.
- Select the desired cutting height
using the comb height selector (H).
Press it and adjust the height accor-
ding to the desired cutting length.
How to cut the hair:
- Situate the person whose hair you
10/10/11 11:01
Publicidad
