Emerio HAC-112873.1 Manual De Instrucciones página 5

HAC-112873.1
PARTS
1. Round brush
2. Cool shot button
3. Switch board
4. Indicator light
5. Release button
6. Hanging loop
7. Handle
8. Air inlet
Switch board:
"0": off;
"1": warm air flow;
"2": hot air flow.
BEFORE USE
1. Use the unit with dry or towel-dried hair, but never with complete wet hair.
2. Use a conditioner after having washed your hair. Rinse and dry the hair well and comb it out before styling.
All this will make the styling easier.
HOW TO ATTACH OR RELEASE THE ROUND BRUSH
To attach: Insert and twist the round brush into the air outlet end of the main body until you hear a click sound.
To release: Press the release button and twist off the round brush at the same time.
HOW TO USE
1. Always ensure the switch is set to position "0" before plug in the power outlet.
2. Set the switch to position "1" or "2" for warm or hot air flow, the appliance is on and the indicator light is
illuminating.
3. On level "2", the exhausting air and attachment in contact with the hot air will get very hot quickly. Use this
level only short for faster styling to avoid that hair gets too hot.
4. With the "cool shot" function (press and hold the button) you can minimize the temperature during the
treatment. When pressing and moving the button to the front at the same time, the button can be locked
to hold a lower temperature. With the lower temperature the hair is treated more gently and the treatment
can be prolonged.
5. Always allow your hair to cool down a bit before finishing the hairdo by combing the hair out.
Note:
1) For styling, forming, curling, round brush shall be attached to the mainbody. Do not wind too thick strands
of hair around the round brush. Wind a smaller strand of hair, instead. .
2) When using the appliance to create curls and waves, dry hair almost completely on level "2" hot air flow,
then finish styling using level "1" warm air flow. This will set the style in your hair.
3) To avoid over-drying, keep the appliance moving as you style.
CLEANING AND CARE
1. Ensure that the appliance is disconnected from the mains supply and cooled down before cleaning.
2. If necessary the housing can be wiped off with a dry soft cloth without any detergents.
3. Clean the air inlet opening from time to time with a fine brush.
- 4 -
EN