SodaStream SPIRIT ONE TOUCH Guía De Usuario página 5

SET UP
INSTALLING THE CO
1. Place the SodaStream
Fizzi One Touch
TM/MC
sturdy surface and remove the back cover.
2. Remove seal and cap from the SodaStream CO
WARNING! Never insert or replace the CO
while a Plastic Carbonating Bottle is installed in the
Sparkling Water Maker. This can cause the Plastic
Carbonating Bottle to be ejected or burst. Tilt the
Sparkling Water Maker forward and insert the CO
Cylinder in the back of the Sparkling Water Maker.
Gently raise the CO
right until it is firmly held in place. WARNING!
Hand-tighten only. DO NOT use tools; this can damage
the Sparkling Water Maker or CO
result in an uncontrolled flow of CO
Plastic Carbonating Bottle to burst and result in
personal injury or property damage.
3. Connect the power cord to your Sparkling Water Maker.
Run the cord through the slots in the base. Insert the plug
into the wall outlet. The buttons will light up. Only use an
original SodaStream power adapter.
4. Reinstall the back cover. Now you are ready to create the
bubbles.
SODASTREAM CO
Please note that the
SodaStream Spirit One
®/MD
Touch
/ Fizzi One
TM/MC
Touch is compatible
TM/MC
with the SodaStream CO
Screw System Cylinder and
is NOT compatible with the
SodaStream Quick
®/MD
Connect Cylinder.
CYLINDER
2
Spirit One Touch
®/MD
Sparkling Water Maker on a flat
Cylinder and tighten by turning to the
2
Cylinder. This may
2
gas, causing the
2
SCREW SYSTEM CYLINDER
2
COMPATIBLE SODASTREAM
CO SCREW SYSTEM CYLINDER
2
2
Use Only SodaStream
CO Screw System Cylinder
2
/
TM/MC
Cylinder.
2
Cylinder
2
2
®/MD
®/MD
1
1
2
A
3
Flip
4
NON-COMPATIBLE
CO QUICK CONNECT CYLINDER
2
1 5
B