Publicidad
Idiomas disponibles
Idiomas disponibles
CREATE THE BUBBLES
1. Fill the Plastic Carbonating Bottle with cold water up to the fill line.
WARNING! Do not carbonate anything other than water. Other liquids
can contaminate and clog internal parts, potentially resulting in
excessive pressure, bottle failure during carbonation and serious
injury. Never carbonate after flavouring has been added.
2. To insert the Plastic Carbonating Bottle, make sure that the Carbonating
Bottle rest is angled forward. Please make sure you do not pull the
carbonating tube. WARNING! Never use a Sparkling Water Maker with
a broken carbonating tube. This can cause excessive pressure,
bottle failure and serious injury. Insert the Plastic Carbonating
Bottle neck into the Snap-Lock. Push the Plastic Carbonating Bottle
up and back. The Snap-Lock will hold the Plastic Carbonating Bottle.
3. To carbonate, press any of the carbonating buttons and all the buttons
will light up showing that they are active, then press as follows to get the
carbonation level of your choice:
• For 1L Carbonating Bottle: Left button (one drop) for light fizz; Middle
button (two drops) for medium fizz; Right button (three drops) for
strong fizz.
• For 0.5L Carbonating Bottle: Left button (one drop) for medium fizz;
Middle button (two drops) for strong fizz.
4. The button will flash slowly indicating that it is carbonating and will flash
quickly when carbonation is complete. Pressing any button during
carbonation will stop the carbonation process. When the desired level of
carbonation is achieved, gently pull the Carbonating Bottle towards you
until it reaches its fully forward position. This will release the pressure in
the Carbonating Bottle and allow the Carbonating Bottle to be released
from the Snap-Lock. WARNING! Do not remove Plastic Carbonating
Bottle until after hearing the sound of excess CO
Never force the Plastic Carbonating Bottle out of the Snap-Lock. Always
allow the Sparkling Water Maker to release the Plastic Carbonating Bottle.
If the Plastic Carbonating Bottle does not immediately release from the
Snap-Lock wait a few moments. If it still does not release, then push the
Plastic Carbonating Bottle back into the vertical position and gently pull it
towards you again. Attempting to remove the Plastic Carbonating
Bottle while it is still pressurized can cause uncontrolled ejection of
the Plastic Carbonating Bottle and may result in serious injury.
CARE
SPARKLING WATER MAKER CARE
• Never use abrasive cleaners or sharp tools to clean. If needed, use a mild liquid dish soap and a soft
damp cloth to gently clean.
• Wipe spills to keep base dry.
• Do not place in water or wash in a dishwasher, doing so will seriously damage your Sparkling Water
Maker.
PLASTIC CARBONATING BOTTLE CARE
• For Plastic Carbonating Bottles which are not "dishwasher safe", to clean, rinse Plastic Carbonating
Bottles with cold or lukewarm water. WARNING! Do not expose to heat above 120°F / 50°C. Never
wash or rinse in hot water. Do not wash in dishwasher.
• For "dishwasher safe" Plastic Carbonating Bottles, to clean, either wash in dishwasher or rinse Plastic
Carbonating Bottles with cold or lukewarm water. WARNING! Do not expose to heat above 158°F / 70°C.
being released.
2
1
2
B
A
Note: when inserted correctly, there is a
small gap between the bottom of the
Carbonating Bottle and the base. Do not
carbonate if the Carbonating Bottle is
resting on the base, or water will splash out.
3
Note: You may see
small pieces of ice
appear in the water
during carbonation
of very cold water.
Any ice created will
simply melt.
4
1 6
C
Publicidad
