Publicidad
Step 6
Separate the EXTENSION SLIDES (45MC) from the EXTENSION RAILS (45MA) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (45MA) to the ENDS (A and B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through
å
holes #1 and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into
this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
1
Open end
www.sauder.com/service
45MC
4
3
2
B
45MA
2
3
4
A
427307
7
Open end
1
Page 11
Publicidad
