Publicidad
Step 2
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40MA) to the ENDS (A and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S) through
holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
of the EXTENSION RAIL in to find the other hole that lines up with the hole in the ENDS. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(8 used for the RAILS)
2
1
Open end
Page 8
3S
4
3
B
2
1
3
4
4
3
427360
40MA
1
2
2
A
3
4
www.sauder.com/service
7
Open end
1
Publicidad
